Detroit Diesel MBE 4000 Service Manual page 458

7.4 EGR COOLER AND COOLER SUPPORT BRACKET
www.rtrucks.ru
6. Using industrial petroleum grease, insert a membrane into the side of the EGR control
valve that is closest to the EGR cooler. See Figure 7-30.
1. Symmetric membrane
Figure 7-30
7. Lift entire EGR cooler with attached cooler flange and sit this on top of cooler support,
taking care to insert the upper half of the coolant inlet pipe down through the appropriate
hole in the cooler support. At the same time, push the cooler flange into the membrane.
See Figure 7-30.
NOTE:
The oil filter and oil filter cover should be removed for good clearance when removing
and installing the EGR cooler assembly.
7-38
www.rtrucks.ru
Installing Symmetric Membrane into EGR Valve
www.rtrucks.ru
2. EGR Temperature Sensor
6SE412 0403 Copyright © 2004 DETROIT DIESEL CORPORATION
www.rtrucks.ru
www.rtrucks.ru
All information subject to change without notice.
www.rtrucks.ru