www.rtrucks.ru
4. Using an appropriate drift, press the drive shaft and bearing assembly out of the impeller
and through the coolant pump housing. This frees the impeller from the housing.
See Figure 4-7.
1. Sleeve Seal
2. Drift
3. Impeller
Figure 4-7
5. Remove the sleeve seal from the coolant pump housing.
4.2.2.1
Inspect the coolant pump unit as follows:
1. Check all coolant pump components for signs of damage. Replace any damaged
components.
All information subject to change without notice.
6SE412 0403 Copyright © 2004 DETROIT DIESEL CORPORATION
www.rtrucks.ru
Removing the Drive Shaft
Coolant Pump Inspection
www.rtrucks.ru
4. Receptacle
5. Drive Shaft and Bearing Assembly
www.rtrucks.ru
MBE 4000 SERVICE MANUAL
www.rtrucks.ru
4-13
www.rtrucks.ru