Detroit Diesel MBE 4000 Service Manual page 78

1.3 CYLINDER BLOCK
www.rtrucks.ru
5. Install the cylinder liner, using the cylinder liner installation tool
(J 46168 or 449 589 01 33 00). See Figure 1-19.
1. Installation Nut
2. Cylinder Liner
Figure 1-19
[a] If installing a new liner, be sure to make a reference mark on the liner to match up
with the one made on the cylinder block upon removal.
Do not overtighten the installation tool. This may deform the
liner and make the installation tool more difficult to remove.
[b] Tighten the installation tool just enough to hold the installation tool inside the liner
without turning.
To prevent damage to the O-rings, the liner must be rotated
during installation.
NOTE:
If installing a new liner, use the first reference mark. If installing the old liner, use the
second reference mark, offset 90 degrees from the first one.
1-30
www.rtrucks.ru
Cylinder Liner Installation
NOTICE:
NOTICE:
www.rtrucks.ru
3. Cylinder Block
6SE412 0403 Copyright © 2004 DETROIT DIESEL CORPORATION
www.rtrucks.ru
www.rtrucks.ru
All information subject to change without notice.
www.rtrucks.ru