Detroit Diesel MBE 4000 Service Manual page 266

2.4 FUEL INJECTOR NOZZLE
www.rtrucks.ru
7. Attach the impact extractor (355 589 01 63 00) and adaptor (904 589 00 63 00). Thread
the narrow end of the adaptor onto the internal M8 threading in the head of the nozzle.
Thread the impact extractor onto the wide end of the adaptor. See Figure 2-11.
1. Nozzle
2. O-ring
3. Seal Ring
Figure 2-11
NOTE:
Do not attempt to take apart the nozzle. If there is a problem, replace the nozzle.
8. Using the impact extractor (355 589 01 63 00), remove the nozzle from the cylinder
head. Discard the O-ring and the seal ring.
Pull the nozzle straight out of the cylinder head. Do not twist it,
turn it, or use pliers. This could damage the nozzle.
9. Remove the impact extractor (355 589 01 63 00) and adaptor (904 589 00 63 00) from
the nozzle.
10. Cap off or cover the openings in the fuel lines to prevent contamination of the fuel.
2.4.2 Fuel Injector Nozzle Installation
Install the fuel injector nozzle as follows:
2-20
www.rtrucks.ru
Pulling the Nozzle
NOTICE:
www.rtrucks.ru
4. End Cover
6SE412 0403 Copyright © 2004 DETROIT DIESEL CORPORATION
www.rtrucks.ru
www.rtrucks.ru
All information subject to change without notice.
www.rtrucks.ru