www.rtrucks.ru
7.2.4
Install the exhaust brake assembly as follows:
1. Clean the mating surfaces on the brake valve housing and the turbocharger.
2. Install the brake valve housing on the turbocharger by slipping the housing over the
turbocharger studs. Tighten the locknuts 50 N·m (37 lb·ft).
To avoid injury from the sudden release of a high-pressure
hose connection, wear a face shield or goggles.
3. Install the compressed-air line on the exhaust brake cylinder.
4. Clean the sealing surfaces on the exhaust pipe and brake valve housing.
5. Slide the exhaust pipe and clamp over the end of the housing. Tighten the clamp.
6. Install the air cleaner.
7. Connect the batteries, lower the hood, and remove the chocks from the rear tires.
All information subject to change without notice.
6SE412 0403 Copyright © 2004 DETROIT DIESEL CORPORATION
www.rtrucks.ru
Exhaust Brake Assembly Installation
PERSONAL INJURY
www.rtrucks.ru
www.rtrucks.ru
MBE 4000 SERVICE MANUAL
www.rtrucks.ru
7-13
www.rtrucks.ru