3.8
OIL PRESSURE AND TEMPERATURE SENSOR
www.rtrucks.ru
3.8
OIL PRESSURE AND TEMPERATURE SENSOR
Perform the following procedures for removal and installation of the oil pressure and temperature
sensor.
3.8.1
Oil Pressure and Temperature Sensor Removal
Removal the oil pressure and temperature sensor as follows:
1. Loosen the oil filter cap. Lift up the cap and filter to allow the oil to drain. Inspect the
O-ring for damage and replace if necessary.
2. Disconnect the wiring connector from the oil pressure/temperature sensor. See Figure 3-24.
Figure 3-24
3. Remove the oil pressure/temperature sensor.
3.8.2
Oil Pressure and Temperature Sensor Installation
Install the oil pressure and temperature sensor as follows:
1. Position the oil pressure/temperature sensor and install the mounting screws. Tighten the
fasteners 10 N·m (7 lb·ft).
2. Connect the wiring harness at the oil temperature sensor.
3. Using a new O-ring (if necessary), install the oil filter cap. Tighten the nut 25 N·m (18
lb·ft).
3-32
www.rtrucks.ru
Sensor Installation
www.rtrucks.ru
6SE412 0403 Copyright © 2004 DETROIT DIESEL CORPORATION
www.rtrucks.ru
www.rtrucks.ru
All information subject to change without notice.
www.rtrucks.ru