Detroit Diesel MBE 4000 Service Manual page 381

www.rtrucks.ru
3. Locate the temperature sensor behind the engine harness, between unit pumps #2 and
#3. See Figure 4-19.
1. Cylinder Block
2. High-Pressure Fuel Line
Figure 4-19
4. Remove the electrical connector from the sensor.
5. Unscrew the sensor from the wall of the cylinder block.
4.7.2
Assemble the coolant temperature sensor as follows:
1. Screw the new sensor into the hole in the cylinder block, as removed.
2. Connect the electrical connector to the sensor. Make sure the connection is secure.
3. Install the engine trim panel.
4. Fill the engine with coolant, and check for leaks and proper operation.
All information subject to change without notice.
6SE412 0403 Copyright © 2004 DETROIT DIESEL CORPORATION
www.rtrucks.ru
Coolant Temperature Sensor Location
Coolant Temperature Sensor Assembly
www.rtrucks.ru
3. Coolant Temperature Sensor
4. Engine Harness
www.rtrucks.ru
MBE 4000 SERVICE MANUAL
www.rtrucks.ru
4-33
www.rtrucks.ru