Detroit Diesel MBE 4000 Service Manual page 509

www.rtrucks.ru
2. Install the four air compressor mounting bolts. Tighten each bolt 60 N·m (44 lb·ft).
See Figure 10-4.
NOTE:
Be sure the correct mounting bolt is mounted at each location. The outboard upper
mounting bolt is installed from the rear.
3. Install the two coolant lines.
[a] Replace the seal rings on the coolant lines.
[b] Install the coolant delivery line at the rear of the air compressor. Tighten the
hollow-core banjo bolt 30 N·m (22 lb·ft).
[c] Install the coolant return line at the front of the air compressor. Tighten the
hollow-core banjo bolt 30 N·m (22 lb·ft).
4. Install the engine trim cover.
5. Install the three air lines. See Figure 10-2.
[a] Install the discharge line and the 90 elbow. Make sure the O-ring is properly
installed on the fitting.
[b] Install the uploader line. Make sure the O-ring is properly installed on the fitting.
[c] Tighten the fittings 80 N·m (60 lb·ft).
[d] Install the intake air line and tighten the hose clamp.
6. Install the cross plate. Use grease to hold it in place while installing the power steering
pump.
7. Install the two bolts attaching the power steering pump to the air compressor. Tighten the
bolts 40 N·m (30 lb·ft).
8. Fill the radiator with coolant.
All information subject to change without notice.
6SE412 0403 Copyright © 2004 DETROIT DIESEL CORPORATION
www.rtrucks.ru
www.rtrucks.ru
www.rtrucks.ru
MBE 4000 SERVICE MANUAL
www.rtrucks.ru
10-9
www.rtrucks.ru