Detroit Diesel MBE 4000 Service Manual page 363

Hide thumbs Also See for MBE 4000:

Table of Contents

www.rtrucks.ru

[a] Place the coolant pump housing in a press.

[b] Place the coolant pump pressure piece, (J 45388 of 355 589 02 43 00), over the

outer bearing race.

[c] Place the receptacle, (J 45388 of 355 589 02 43 00), under the coolant pump housing.

To prevent damage to the drive shaft and bearing assembly,

press only on the outer bearing race.

[d] Press the outer race of the bearing into the coolant pump housing.

2. Secure the bearing in place with the snap ring.

To avoid injury from hot surfaces, wear protective gloves,

or allow engine to cool before removing any component.

3. Press the hub onto the drive shaft and bearing assembly.

[a] Heat the hub to 175 F (80 C).

To prevent damage to the bearing, make sure the drive shaft

is supported evenly before pressing on the hub.

[b] Press the hub onto the drive shaft, while holding the bearing and drive shaft assembly

to prevent it from turning. Make sure the hub is flush with the end of the drive shaft.

All information subject to change without notice.

www.rtrucks.ru

PERSONAL INJURY

www.rtrucks.ru

MBE 4000 SERVICE MANUAL

www.rtrucks.ru

www.rtrucks.ru

Chapters

Table of Contents