www.rtrucks.ru
1.4.2
There is also drilling in the head to attach the new EGR cooler support bracket. There is hardening
at block division face of cylinder head also. See Figure 1-30.
1. Drilling to attach the EGR Cooler Support Bracket
Figure 1-30
1.4.3
One difference between the non-EGR cylinder liner to the EGR model is a groove on the top part
of the cylinder liner, which houses the carbon scraper ring. See Figure 1-29. The carbon scraper
ring for the EGR engine is in the area previously hardened in the non-EGR cylinder liner. Its
purpose is to inhibit coke formation.
All information subject to change without notice.
6SE412 0403 Copyright © 2004 DETROIT DIESEL CORPORATION
www.rtrucks.ru
Cylinder Head Changes
EGR Cylinder Head Changes
Cylinder Liner Changes
www.rtrucks.ru
2. Hardening at Block Division Face
www.rtrucks.ru
MBE 4000 SERVICE MANUAL
www.rtrucks.ru
1-41
www.rtrucks.ru