www.rtrucks.ru
2. Push the piston into cylinder liner, using ring compressor J tool (J 45983) to compress the
piston rings.
3. Clean the carbon scraper ring seat in the cylinder liner.
4. After piston is installed, install carbon scraper ring in the cylinder liner groove.
See Figure 1-104.
5. Check carbon scraper ring for correct fit after installation.
6. Follow remaining steps for piston installation in a non-EGR engine .
Refer to section 1.17.2.
All information subject to change without notice.
6SE412 0403 Copyright © 2004 DETROIT DIESEL CORPORATION
www.rtrucks.ru
www.rtrucks.ru
www.rtrucks.ru
MBE 4000 SERVICE MANUAL
www.rtrucks.ru
1-137
www.rtrucks.ru