Detroit Diesel MBE 4000 Service Manual page 224

Hide thumbs Also See for MBE 4000:

Table of Contents

CAMSHAFT AND CAMSHAFT SENSOR

www.rtrucks.ru

6. Install the fuel pump drive gear on the front of the camshaft, as removed. Torque the

bolts to 60 N·m (44 lb·ft.)

7. Turn the engine on the stand until it is right side up.

8. Install the unit pumps. Refer to section 2.1.2.

9. Install the camshaft front cover on the cylinder block, as removed. Torque the mounting

bolts to 50 N·m (37 lb·ft.)

10. Install the fan support.

11. Install the vibration damper. Refer to section 1.11.2.

12. Lubricate the pushrods with a light coating of clean engine oil. Install the pushrods and

the rocker arm assembly. Refer to section 1.21.4.

To avoid injury from a falling component, ensure a proper

lifting device is used.

13. Remove the engine from the stand and install it on the vehicle.

14. Fill the engine with oil.

Camshaft Inspection

Inspect the camshaft as follows:

To get a correct hardness reading, it is critical to place a hard base below the cam or

bearing journal.

www.rtrucks.ru

FALLING COMPONENT

www.rtrucks.ru

All information subject to change without notice.

www.rtrucks.ru

Chapters

Table of Contents