Dc Voltage - Keysight Truevolt Series Operating And Service Manual

DC Voltage

This section describes how to configure DC voltage measurements from the front panel, including DCV
ratio measurements.
Step 1: Configure the test leads as shown.
Step 2: Press [DCV] on the front panel.
Step 3:
For the 34460A/61A , press Aperture and choose the number of power-line cycles (PLCs) to use for
l
the measurement. Only 1, 10, and 100 PLC provide normal mode (line frequency noise) rejection.
Selecting 100 PLC provides the best noise rejection and resolution, but the slowest measurements:
Keysight True volt Series Operating and Service Guide
Features and Functions
57