Keysight Truevolt Series Operating And Service Manual page 278

LXI:RESet
Resets LAN settings to a known operating state, beginning with DHCP, and clears the Web Interface pass-
word. If DHCP fails, it uses Auto-IP.
Parameter Typical Return
(none) (none)
Reset the LAN settings:
LXI:RES
Depending on your network, the LAN interface may take several seconds to restart after this command
l
is sent.
If the LAN interface or specific LAN services (VXI-11, sockets, and so on) have been disabled by
l
SYSTem:COMMunicate:ENABle, you must separately re-enable the interface or services and cycle
instrument power for the LAN to be operational.
LXI:RESTart
Restarts the LAN with the current settings as specified by the
Parameter Typical Return
(none) (none)
Restart the LAN interface:
LXI:REST
Depending on your network, the LAN interface may take several seconds to restart after this command
l
is sent.
If the LAN interface or specific LAN services (VXI-11, sockets, and so on) have been disabled by
l
SYSTem:COMMunicate:ENABle, you must separately re-enable the interface or services and cycle
instrument power for the LAN to be operational.
Keysight True volt Series Operating and Service Guide
SCPI Programming Reference
SYSTem:COMMunicate:LAN commands.
279