Power-On And Reset State - Keysight Truevolt Series Operating And Service Manual

SCPI Programming Reference

Power-On and Reset State

These tables show factory default settings. Parameters marked with a bullet (•) are nonvolatile and are not
affected by power-on or system reset. Other parameters are volatile and are reset to the indicated values
at power-on or after *RST
The power-on/reset state may differ from these values if you have enabled
power-on state recall mode.
Factory Default Settings
Measurement Configuration
Function
Range
Integration Time
Resolution
Autozero
Aperture (34465A/70A only)*
Frequency or Period Aperture (Gate Time)
• Input Impedance
AC Input Filter (bandwidth)
Temperature Transducer Type
RTD Reference Resistance
Nulls (individual functions)
Current Terminals
Secondary Measurements
Screen Shot Format
Calibration Value
Current Switch Mode (34465A/70A only)
Resistance (2- and 4-wire) (34465A/70A only):
Offset Compensation
Low Power Measurements
Temperature (34465A/70A only):
Offset Compensation (2- and 4- wire RTD)
Low Power Measurements(2- and 4- wire RTD or thermistor) Off
Thermocouple (34465A/70A only):
Check
Reference Junction Temperature, Type, Adjust
Thermocouple Type
* For all DC measurement functions.
474
or SYSTem:PRESet.
DC Volts
Autorange (for all functions)
NPLC On, 10 power line cycles (PLC)*
Resolution equivalent to 10 PLC
On*
Off, 100 ms
100 ms*
• 10 MΩ (fixed for all DC voltage ranges)
20 Hz (medium filter)
FRTD
100 Ω
Off; reference = 0.0, auto reference enabled
(for all measurement functions)
3 A
Off
PNG
0.0
Continuous
Off
Off
Off
Off
0° C, Internal, 0° C
J
Factory Setting
Keysight True volt Series Operating and Service Guide