Keysight Truevolt Series Operating And Service Manual page 241

SCPI Programming Reference
See Also
SYSTem:TIME
SYSTem:DATE
CALibration:VALue < value >
CALibration:VALue?
Specifies the value of the applied calibration signal.
You must unsecure the instrument to calibrate it or to change the calibration code or security code.
Parameter Typical Return
Numeric, default 0.0 +2.37000000E-02
Specify calibration value 0.0237:
CAL:VAL 2.37E-2
This parameter is set to its default value after a Factory Reset (*RST) or Instrument Preset
l
(SYSTem:PRESet).
242 Keysight True volt Series Operating and Service Guide