Safety Information; General - Keysight Truevolt Series Operating And Service Manual

Safety and Regulatory Information
This product complies with the WEEE Directive (2002/96/EC) marking equipment. The affixed
product label indicates that you must not discard this electrical/electronic product in
domestic household waste.
To return unwanted products, contact your local Keysight office, or see
sight.com/environment/product/
This equipment is Class A suitable for professional use and is for use in electromagnetic envir-
onments outside of the home.
Contains one or more of the 6 hazardous substances above the maximum concentration value (MCV), 40
Year EPUP.

Safety Information

General

Do not use this product in any manner not specified by the manufacturer. The protective features of this
product may be impaired if it is used in a manner not specified in the operation instructions. Do not install
substitute parts or perform any unauthorized modification to the product. Return the product to a Key-
sight Technologies Sales and Service Office for service and repair to ensure that safety features are main-
tained.
Product Grounding
The instrument is a Class 1 product and is provided with a grounding-type power cord set. The instru-
ment chassis and cover are connected to the instrument electrical ground to minimize shock hazard.
The ground pin of the cord set plug must be firmly connected to the electrical ground (safety ground)
terminal at the power outlet. Any interruption of the protective earth (grounding) conductor or dis-
connection of the protective earth terminal will cause a potential shock hazard that could result in per-
sonal injury or death.
Cleaning
To prevent electrical shock, disconnect the instrument from AC mains power and disconnect all test
leads before cleaning. Clean the outside of the instrument using a soft, lint-free, cloth slightly
dampened with water.Do not use detergent or solvents.Do not attempt to clean internally.If needed,
contact a Keysight Technologies Sales and Service office to arrange for proper cleaning to ensure
that safety features and performance are maintained.
AC Power Cord
Removal of the AC power cord is the disconnect method to remove power from the instrument. Be
sure to allow for adequate access to the power cord to permit disconnection from AC power. Use
only the Keysight specified power cord for the country of use or one with equivalent ratings.
14
for more information.
Keysight True volt Series Operating and Service Guide
www.key-