Keysight Truevolt Series Operating And Service Manual page 370

[SENSe:]TEMPerature:ZERO:AUTO {OFF|ON|ONCE}
[SENSe:]TEMPerature:ZERO:AUTO?
Disables or enables the autozero mode for 2-wire temperature measurements.
ON (default): the DMM internally measures the offset following each measurement. It then subtracts
l
that measurement from the preceding reading. This prevents offset voltages present on the DMM's
input circuitry from affecting measurement accuracy.
OFF: the instrument uses the last measured zero measurement and subtracts it from each meas-
l
urement. It takes a new zero measurement each time you change the function, range or integration
time.
ONCE: the instrument takes one zero measurement and sets autozero OFF. The zero measurement
l
taken is used for all subsequent measurements until the next change to the function, range or integ-
ration time. If the specified integration time is less than 1 PLC, the zero measurement is taken at 1 PLC
to optimize noise rejection. Subsequent measurements are taken at the specified fast (< 1 PLC) integ-
ration time.
Parameter
{OFF|ON|ONCE}. Default: ON.
Configure 2-wire RTD measurements and perform an immediate zero autozero. Make and read two meas-
urements:
CONF:TEMP RTD
TEMP:ZERO:AUTO ONCE
SAMP:COUN 2
READ?
Typical Response: +2.57530000E+01,+2.57570000E+01
Does not affect 4-wire resistance measurements, which are always made with autozero ON.
l
The autozero mode is set indirectly when you set the resolution and integration time using
l
ure:TEMPerature or MEASure:TEMPerature?. Autozero is automatically turned OFF when you select
an integration time less than 1 PLC with these commands.
This parameter is set to its default value after a Factory Reset (*RST) or Instrument Preset
l
(SYSTem:PRESet).
Keysight True volt Series Operating and Service Guide
SCPI Programming Reference
Typical Return
0 (OFF) or 1 (ON)
CONFig-
371