Keysight Truevolt Series Operating And Service Manual page 299

SCPI Programming Reference
MMEMory:STATe:RECall:SELect < file >
MMEMory:STATe:RECall:SELect?
Selects which instrument state to use at power-on if the automatic recall mode is enabled
(MMEMory:STATe:RECall:AUTO
(MMEMory:STATe:RECall:AUTO
Parameter
Any valid file name
Select the power-down state to be used at power-on.
MMEM:STAT:REC:SEL "INT:\STATE_0"
MMEM:STAT:REC:AUTO ON
Save the current state into a file in the root directory of the internal flash file system and load it at power-on:
MMEM:STOR:STAT "INT:\MyVoltMeas"
MMEM:STAT:REC:SEL "INT:\MyVoltMeas"
MMEM:STAT:REC:AUTO ON
The specified folder must exist and cannot be marked as hidden or system.
l
The state file created by *SAV 0, called STATE_0.sta, resides in the root folder of the internal flash file
l
system. It is overwritten with the power-down state of the instrument when power is cycled.
When shipped from the factory, the instrument is configured to automatically recall the power-down
l
state file when power is restored.
This setting is non-volatile; it is not changed by power cycling, a Factory Reset (*RST), or an Instru-
l
ment Preset (SYSTem:PRESet).
MMEMory:STATe:VALid? < file >
Returns 1 if the specified state file exists and contains a valid state file. Returns 0 otherwise.
Parameter
Any valid file name
Return the status of MyState.sta in the root folder of the internal flash file system.
MMEM:STAT:VAL? "INT:\MyState.sta"
The specified folder must exist and cannot be marked as hidden or system.
l
The specified file cannot be empty or marked as hidden or system.
l
Use this query before sending
l
stored in the file.
300
ON). If the automatic recall mode is disabled
OFF), a Factory Reset (*RST) is issued at power-on.
"INT:\MyVoltMeas"
Typical Return
1
*RCL or MMEMory:LOAD:STATe
Typical Return
to determine whether a state has been
Keysight True volt Series Operating and Service Guide