Keysight Truevolt Series Operating And Service Manual page 406

SYSTem:COMMunicate:GPIB:ADDRess < address >
SYSTem:COMMunicate:GPIB:ADDRess?
Assigns instrument's GPIB (IEEE-488) address, which is displayed at power-on. Each device on the GPIB
interface must have a unique address.
The GPIB interface is an optional feature. See
Parameter Typical Return
0 to 30, default 22 +15
Set GPIB address to 15:
SYST:COMM:GPIB:ADDR 15
Your computer's GPIB interface card has its own address. Avoid using this address for any instrument
l
on the GPIB bus.
Cycle power for this command to take effect.
l
GPIB is enabled or disabled by SYSTem:COMMunicate:ENABle.
l
The GPIB interface is an optional feature. See
l
This setting is non-volatile; it is not changed by power cycling, a Factory Reset (*RST), or an Instru-
l
ment Preset (SYSTem:PRESet).
This parameter is set to its default value when the instrument is shipped from the factory and after
l
SYSTem:SECurity:IMMediate.
Keysight True volt Series Operating and Service Guide
Models and Options
Models and Options for details.
SCPI Programming Reference
for details.
407