Keysight Truevolt Series Operating And Service Manual page 301

SCPI Programming Reference
Folder and file formats
Many MMEMory commands refer to folders and files. These have specific structures, described below.
folder
Format for a < >
The format for < folder > is "[[< drive >:]< path >]", where < drive > can be INTernal or USB, and < path > is
l
a folder path, and < filespec > specifies a subset of files.
INTernal specifies the internal flash file system. USB specifies a front panel USB storage device.
l
If < drive > is specified, < path > is interpreted as an absolute folder path. Absolute paths begin with "\"
l
or "/" and start at the root folder of < drive >.
If < drive > is omitted, < path > is relative to the folder specified by MMEMory:CDIRectory. Relative
l
paths must NOT begin with \ or /.
Folder and file names cannot contain the following characters: \ / : * ? " < > |
l
The < folder > parameter cannot exceed 240 characters.
l
The specified folder must exist and cannot be marked as hidden or system. The exception is
l
MMEMory:MDIRectory, which creates a folder. For MMEMory:MDIRectory, all folder levels above the
new one must exist.
file
Format for a < >
The format for a file name is "[[< drive >:]< path >]< file_name >", where < drive > can be INTernal or USB,
l
and < path >is a folder path.
INTernal specifies the internal flash file system. USB specifies a front panel USB storage device.
l
If < drive > is specified, < path > is interpreted as an absolute folder path. Absolute paths begin with "\"
l
or "/" and start at the root folder of < drive >.
If < drive > is omitted, < path > is relative to the folder specified by MMEMory:CDIRectory. Relative
l
paths must NOT begin with \ or /.
Folder and file names cannot contain the following characters: \ / : * ? " < > |
l
The combination of folder and file name cannot exceed 240 characters.
l
302 Keysight True volt Series Operating and Service Guide