Keysight Truevolt Series Operating And Service Manual page 296

Command Summary
MMEMory:LOAD:PREFerences
MMEMory:STORe:PREFerences
MMEMory:LOAD:STATe
MMEMory:STORe:STATe
MMEMory:STATe:RECall:AUTO
MMEMory:STATe:RECall:SELect
MMEMory:STATe:VALid?
Folder and file formats
Many MMEMory commands refer to folders and files. These have specific structures, described below.
folder
Format for a < >
The format for < folder > is "[[< drive >:]< path >]", where < drive > can be INTernal or USB, and < path > is
l
a folder path, and < filespec > specifies a subset of files.
INTernal specifies the internal flash file system. USB specifies a front panel USB storage device.
l
If < drive > is specified, < path > is interpreted as an absolute folder path. Absolute paths begin with "\"
l
or "/" and start at the root folder of < drive >.
If < drive > is omitted, < path > is relative to the folder specified by MMEMory:CDIRectory. Relative
l
paths must NOT begin with \ or /.
Folder and file names cannot contain the following characters: \ / : * ? " < > |
l
The < folder > parameter cannot exceed 240 characters.
l
The specified folder must exist and cannot be marked as hidden or system. The exception is
l
MMEMory:MDIRectory, which creates a folder. For MMEMory:MDIRectory, all folder levels above the
new one must exist.
file
Format for a < >
The format for a file name is "[[< drive >:]< path >]< file_name >", where < drive > can be INTernal or USB,
l
and < path >is a folder path.
INTernal specifies the internal flash file system. USB specifies a front panel USB storage device.
l
If < drive > is specified, < path > is interpreted as an absolute folder path. Absolute paths begin with "\"
l
or "/" and start at the root folder of < drive >.
If < drive > is omitted, < path > is relative to the folder specified by MMEMory:CDIRectory. Relative
l
paths must NOT begin with \ or /.
Folder and file names cannot contain the following characters: \ / : * ? " < > |
l
The combination of folder and file name cannot exceed 240 characters.
l
Keysight True volt Series Operating and Service Guide
SCPI Programming Reference
297