Link Layer Discovery Protocol (Lldp) Commands - D-Link xStack DES-3528 Series Cli Reference Manual

xStack® DES-3528/DES-3552 Series Layer 2 Managed Stackable Fast Ethernet Switch CLI Reference Guide

Link Layer Discovery Protocol (LLDP) Commands

The Link Layer Discovery Protocol (LLDP) commands in the Command Line Interface (CLI) are listed (along with the
appropriate parameters) in the following table.
Command
enable lldp
disable lldp
config lldp
config lldp
config lldp
config lldp
config lldp notification_interval
config lldp ports
config lldp ports
config lldp ports
config lldp ports
config lldp ports
config lldp ports
config lldp ports
config lldp ports
config lldp ports
config lldp forward_message
show lldp
show lldp mgt_addr
show lldp ports
show lldp local_ports
show lldp remote_ports
show lldp statistics
show lldp statistics ports
config lldp_med fast_start
repeat_count
config lldp_med log state
config lldp_med notification
topo_change ports
config lldp_med ports
show lldp_med
Parameters
message_tx_interval <sec 5 - 32768 >
message_tx_hold_multiplier < 2 – 10 >
tx_delay < sec 1 - 8192 >
reinit_delay < sec 1 - 10 >
<sec 5-3600>
[<portlist> | all] notification [enable | disable]
[<portlist> | all] admin_status [tx_only | rx_only | tx_and_rx | disable]
[<portlist> | all] [mgt_addr [ipv4 <ipaddr> | ipv6 <ipv6addr>] [enable | disable]]
[<portlist> | all] basic_tlvs [{all} | {port_description | system_name |
system_description | system_capabilities}(1)] [enable | disable]
[<portlist> | all] dot1_tlv_pvid [enable | disable]
[<portlist> | all] dot1_tlv_protocol_vid [vlan [all | <vlan_name 32> ] | vlanid
<<vidlist> > ] [enable | disable]
[<portlist> | all] dot1_tlv_vlan_name [vlan [all | <vlan_name 32> ] | vlanid
<vidlist> ] [enable | disable]
[<portlist> | all] dot1_tlv_ protocol_identity[all | { eapol | lacp | gvrp | stp }(1)]
[enable | disable]
[<portlist> | all] dot3_tlvs [{all} | {mac_phy_configuration_status | link aggregation
| power_via_mdi | maximum_frame_size}(1)] [enable | disable]
[enable | disable]
{[ipv4 {<ipaddr>} | ipv6 {<ipv6addr>}]}
{<portlist>}
{ <portlist>} {mode [brief | normal | detailed]}
{<portlist>} {mode [brief | normal | detailed]}
{<portlist>}
<value 1-10>
[enable | disable]
[<portlist> | all] state [enable | disable]
[<portlist> | all] med_transmit_capabilities [all | {capabilities | network_policy |
power_pse | inventory}] state [enable | disable]
386