To Add A Vlan-Enabled Port Set And Vlan Subnet; To Add Nodes To A Network Configuration - HPE StoreOnce 6500 User Manual

NOTE: Before activating an edited custom configuration, you may like to create a copy of the current
configuration and save it to a different name. Once current is overwritten it cannot be restored.
Procedure
1. Select the configuration that you wish to edit and click Edit.
2. This displays the same dialog box as for creating a subnet and you may edit the subnet configuration
settings. Exceptions are:
• The subnet name may not be changed.
• The network protocol (IPv4/IPv6/DHCP) may not be changed if there are Encryption Links present
for that subnet. This is because encryption links are not allowed for IPv6 or DHCP subnets. If the
user edits a subnet with Encryption links configured, the protocol radio boxes will be greyed out
with the message (or tool tip) "Network Protocol cannot be changed as there are Encryption Links
configured for this subnet."
3. Make changes to the editable fields, as appropriate, and click Save. Some examples are described
below.
To add a VLAN–enabled Port Set and VLAN Subnet
Procedure
1. Select the configuration in the Custom Network Configuration list and click Edit.
2. In the Port set section, click Add.
3. Enter Port Set details, in exactly the same way as when creating a new configuration.
a. Select the required 1 Gbit or 10 Gbit ports. Available ports are active for selection; ports already
assigned are greyed out.
b. If multiple ports have been selected, select a Bond Mode as appropriate. This should be Mode 1 or
Mode 4 for VLAN.
c.
The Type must be set to Data.
4. Be sure to check the VLAN Tagging Enable box and click OK.
5. In the Subnet section, click Add.
6. Enter Subnet details, in exactly the same way as when creating a new configuration, and be sure to
add the VLAN tag ID. Click OK.
7. Save and validate the changes. If required, you can also activate the configuration at this point.

To add nodes to a network configuration

Procedure
1. Select the configuration in the Custom Network Configuration list and click Edit.
2. Select a Port Set and Subnet.
212 To add a VLAN–enabled Port Set and VLAN Subnet