Select Device (Appliance Federated Stores Tab Only); Device Status Reports - HPE StoreOnce 6500 User Manual

Field
Device name
Appliance address
Service set
Device type

Select device (appliance Federated Stores tab only)

In the Select Device dialog box, you will see a list of devices. Select the devices you want to include in
your report and click OK.
Field
Device name
Service set

Device status reports

To obtain a device status report:
Procedure
1. On the Reports page, select Device.
2. In the Group menu, select the device group you want to run a report for.
The resulting report details data for all devices in the selected group.
NOTE: Devices that are in an Unknown state do not contribute to the user data stored, size on disk, or
the deduplication ratio shown in this report. Devices in Fault or Failed to Start states do contribute to
these reported values.
Data type
User data stored
Size on disk
Device name
Description
The amount of user data stored in GB.
The size on disk in GB.
The name of the device.
Select device (appliance Federated Stores tab only)
Description
The name given to the device when it was created
The IP address or domain name of the host
appliance for the device
The service set the device belongs to
The device type: VTL, NAS share, StoreOnce
Catalyst
NOTE: The device type will have the label
(Dedupe disabled) if deduplication is not enabled
on the device.
Description
The name given to the device when it was created
The service set the device belongs to
Table Continued
157