Snmp Gui Functions; Test Snmp Agent Setup; Modifying The Snmp Agent Setup - HPE StoreOnce 6500 User Manual

Procedure
1. From the Navigator, select Device Configuration > Email > Events
2. Click Manage Email Notifications.
3. On the Manage Email Notifications dialog, do one of the following:
a. Choose an existing email address from the drop-down menu and click Select to display it in the
Update events for addresses field.
b. Enter a new address directly into the Update events for addresses field.
4. Select the event groups to be associated with the addresses (Alert, Warn, and/or Info).
5. Click OK.
The updated list is displayed almost immediately in the Events Notified by Email page.

SNMP GUI functions

The SNMP (Simple Network Management Protocol) GUI page allows you to view and modify SNMP
Agent configuration parameters, view common attributes for Registered Trapsinks, and view the Users
list. You can also add, modify, and delete both trapsinks and users.
When the SNMP feature is enabled, it reports the overall system status via SNMP traps as reflected on
the StoreOnce Management interface, as follows:
• OK – System status is good.
• Warning – Something on the system needs attention, but is not critical.
• Critical – Something on the system needs immediate attention.
It also reports any software status messages or hardware status messages as reported in the event log,
email alerts, or the StoreOnce Management Console.

Test SNMP Agent Setup

Once SNMP has been configured, you can use the SNMP Test function to test that SNMP is set up
correctly and that traps can successfully make it to the trapsinks.
Procedure
1. In the SNMP Agent Setup pane, click Test.
2. In the Test SNMP event window, click Yes.

Modifying the SNMP Agent Setup

Procedure
1. From the Navigator, select Device Configuration > SNMP.
2. Click Modify.
3. In the Modify SNMP Agent window, modify the configuration of the SNMP Agent as needed.
178 SNMP GUI functions