To Delete Encryption Links; To Write Protect Or Un-Protect A Configuration; Deleting A Custom Configuration - HPE StoreOnce 6500 User Manual

To delete encryption links

Procedure
1. Select a Subnet and look at the "Encryption Link" section of the Network page. It shows all existing
Encryption Links for that subnet or the text "No Encryption Links" if none have been configured.
2. Select the row for the Encryption Link to be deleted and click Delete.
3. A Warning dialog is displayed. Check the details for the subnet and the IP address of the remote
device to verify that you have selected the correct encryption link to delete. Press OK.
4. The Encryption Link is removed from the StoreOnce subnet configuration. You must also remove the
corresponding encryption link configuration from the backup client or other StoreOnce appliance to
maintain connectivity.

To write protect or un-protect a configuration

Select the configuration in the Custom Network Configuration list and click Edit.
Click in the Protected checkbox to change its status and click Save.
Repeat this process to switch the status back to Un-protected.

Deleting a custom configuration

You may only delete Custom configurations. You cannot delete the current or the
Factory_Default_Configuration.
Procedure
1. Select the required configuration in the Custom configuration list and click Delete.
NOTE: You may not delete a subnet if there are encryption links configured for that Subnet. You must
first delete the encryption links. See To delete encryption links on page 215.
2. At the prompt click OK to confirm the deletion.
TIP: If you delete the custom configuration that has been activated to become the current
configuration, you are effectively deleting your backup of the current configuration. This means
that if you need to modify the current configuration, you will have no backup of it unless you copy
it first.
To delete encryption links 215