HPE StoreOnce 6500 User Manual page 207

Field name
Protocol: IPv4 or IPv6
DNS Address 1/2/3
Step 2: Create Port Sets
• On the Port Set bar click Add to create the first Port Set.
• Enter a name for the Port Set and select the ports to use. Available ports depend upon the model of
StoreOnce System and whether ports have already been assigned. Only those ports that are available
are active for selection; others are greyed out if they are already in use.
• Some hardware products support optional PCI-E cards for 10 Gbit Ethernet. If your system has these
cards installed and activated, they are included in the Ports section with the network type clearly
indicated.
• See Optional hardware on page 194 for more information about optional hardware.
• Click on the Show Port Picture link to display a picture of the rear of the model with ports labeled.
• If multiple ports are selected, the Bond Mode selection will be active. Select a Type. Multi-node
systems must have one, and only one, Port Set that is designated for Management (or both
management and data).
• If required, check the VLAN Tagging Enable box and click OK.
NOTE: VLAN tagging is not supported with Bonding Mode 6.
• At this point you may choose to define the Subnets for the Port Set or to create additional Port Sets by
clicking on Add in the Port set section. For the purposes of this example, we continue to the Subnet
configuration.
TIP: Save the network configuration at regular intervals.
If you save a configuration where there is a PortSet created with no subnets, the data type of
that PortSet will revert to "Data." If the intention was that it would be a Management or
Management + Data Port Set, you must reset the Type before creating the subnet.
NOTE: For Management or Management + Data Port Sets, you can configure static routing for the
management subnet if required as described in To set up static routing.
Step 3: Create Subnets
• Select the Port Set.
• Click Add in the Subnet section.
• Select the number of nodes to configure. The default is the current number of nodes in the cluster, the
minimum being 2, and the maximum is 8.
Description
The radio button selected defines the Internet
Protocol for the DNS servers.
Up to three IPv4 and/or IPv6 DNS addresses may
be defined. The format of the address details is as
appropriate for the protocol selected.
Network configuration 207