Adding An Snmp Trapsink; Modifying An Snmp Trapsink - HPE StoreOnce 6500 User Manual

Adding an SNMP trapsink

Procedure
1. From the Navigator, select Device Configuration > SNMP.
2. On the SNMP Trapsinks tab, click Add.
3. In the Add New Trapsink window, select the protocol (IPv4 or IPv6).
4. Enter the IP address of the host that will receive the SNMP traps.
5. Select the Events that will be sent to the SNMP trap.
The default is INFO.
6. Enter the port number of the host.
The default is 162.
7. Select the version of the trapsink.
The default is 1.
NOTE: SNMP version 1 will incorrectly report the IP address of a trap source when in an IPv6
configuration. HPE recommends using SNMP version 2 or higher when in an IPv6 configuration.
8. If you selected version 3, the window expands to display additional fields.
a. Enter the User Name.
b. Select the Auth Algorithm.
The default is MD5.
c. Enter the Auth (user authentication) Password.
The default is no password set. Passwords must contain at least eight characters. Optional.
d. Select the Priv Alogrithm.
The default is DES.
e. Enter the Priv (privacy) Password for SNMP version 3 and decryption.
The default is no password set. Passwords must contain at least eight characters. Optional.
f. Enter the Context Name. Optional.
9. Click OK.
10. In the Success window, click OK.

Modifying an SNMP trapsink

Procedure
1. From the Navigator, select Device Configuration > SNMP.
2. On the SNMP Trapsinks tab, select the trapsink to modify.
3. Click Modify.
Adding an SNMP trapsink 181