Serial Port Option; Installing The Serial Port - HPE ProLiant DL325 Gen11 User Manual

The System Intrusion Detection setting in the UEFI System Utilities is automatically enabled after installing the chassis intrusion detection
switch. To view a log of intrusion events, use the iLO web interface to access the IML or the iLO event log. For more information, see the iLO
user guide on the Hewlett Packard Enterprise website (https://www.hpe.com/support/ilo-docs

Serial port option

Serial port option
Install the serial port option to enable communication to physical serial devices. You can also use the serial connection to remotely access the
system BIOS and view POST error messages.
Subtopics Subtopics

Installing the serial port

Installing the serial port
Installing the serial port Installing the serial port
Prerequisites Prerequisites
Before you perform this procedure, make sure that you have the following items available:
Hex screwdriver
Spudger or any small prying tool
About this task About this task
CAUTION: CAUTION: A discharge of static electricity from a finger or other conductor might damage system boards or other static-
sensitive devices. To prevent damage, observe antistatic precautions.
CAUTION: CAUTION:
The port blank provides EMI shielding and helps maintain proper thermal status inside the server. Do not operate the server
when a port blank is removed without the corresponding I/O port option installed.
Procedure Procedure
1. Power down the server.
2. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
3. Disconnect all peripheral cables from the server.
4. Remove the server from the rack.
5. Place the server on a flat, level work surface.
6. Remove the access panel .
7. Do one of the following:
Remove the secondary riser cage.
Remove the secondary riser cage blank.
https://www.hpe.com/support/ilo-docs).
HPE ProLiant DL325 Gen11 Server User Guide 182