Quick Restore Iso Image - HPE StoreOnce 6500 User Manual

using the IPsec protocol. View the network configuration using the CLI net show config command to
determine if Data in Flight is configured; see the StoreOnce System CLI Reference Guide.

Quick Restore ISO Image

A Quick Restore (QR) ISO image is available to re-image the software on a StoreOnce appliance to a
known good state. It is only used, under guidance by Hewlett Packard Enterprise Support, in the unlikely
event of a node's root file system becoming corrupted or lost; for example if multiple OS disk failures have
occurred.
CAUTION: If you want to upgrade an existing StoreOnce System installation, always use the
software update from www.hpe.com/support/softwaredepot; do not use the QR ISO image.
CAUTION: The QR process will delete all stored data and configuration settings returning your
product to factory default settings.
However, one failed node in a couplet can be quick restored without data loss, if the system has failed
over to the second node. You will need physical access to the StoreOnce appliance to perform the
update. Contact Hewlett Packard Enterprise Support for advice.
IMPORTANT: All nodes in a cluster of a StoreOnce 6500 and 6600 appliance must be running the
same software build. If using the QR ISO image, the image must be the same revision as the
current software. Hewlett Packard Enterprise recommends that you create new QR media at system
installation and whenever the system software is updated.
CAUTION: Only perform the QR process under the guidance of Hewlett Packard Enterprise
Support. It is not expected to be required to be used during normal use and operation of the
product.
244 Quick Restore ISO Image