To View A Custom Configuration - HPE StoreOnce 6500 User Manual

NOTE:
If the network configuration is changed in a way that affects the management subnet or a new
configuration is created and activated, it will be necessary to reconfigure the static routing information.

To view a custom configuration

To view a custom configuration, select that configuration in Network Configuration under Custom.
Table 63: Custom Network Configuration fields
Field name
Configuration Information
Configuration Name
Protected
DNS Server
DNS Address 1/2/3
Port Sets
Name
Network Ports
Management IP
Bond Mode
Data Type
VLAN
210 To view a custom configuration
Description
The name given to the configuration when it was created.
Indicates protection status. Click in the box to prevent further editing of the
configuration. To release the write protection, click in the box to uncheck it.
Shows up to three DNS addresses that were defined at configuration.
The format of the address detail is as appropriate for the protocol selected
(IPv4 or IPv6).
The name given to the Port Set when it was created.
The ports that were defined for use by this Port Set.
The IP address for the Management Console. This is the IP address that is
used to log on to the StoreOnce Management GUI or CLI.
Any Bond mode that has been defined. Bond modes are only appropriate if
there is more than one port in the Port Set.
It may be Data, Management or Both. One, and only one, Port Set is defined
for Management. Once Management Data Type or Both has been selected
for a Port Set, the only option remaining for other Port Sets is Data.
Indicates whether VLAN tagging has been enabled for the Port Set.
VLANs may only be enabled on Data Port Sets.
Table Continued