Editing A Custom Configuration - HPE StoreOnce 6500 User Manual

Field name
Configuration Information
Frame size
Speed
Subnet Ports
Name
VLAN
Gateway IP
Network Mask
Domain Name
Default Subnet
Node tab
Physical IP address and
Virtual IP address on a
Node tab
Encryption Links
Client IP address
PassPhrase

Editing a custom configuration

You cannot edit the current or the Factory_Default_Configuration. However, you can edit any
configuration in the Custom configuration list. If the StoreOnce CLI wizard was used to configure the
network at installation, there will be at least one custom configuration in the list, net_wizard.
Description
This defines the amount of data contained in an Ethernet frame, the default is
1500 bytes. Larger size frames, often referred to as "Jumbo" frames, can
improve performance of the Port Set. Use this field to increase or decrease
the value, which must be an integer between 1280 and 9000.
IMPORTANT: Other devices on the network (clients and switches)
must also be configured to enable Jumbo frames for transfer of frames
larger than 1500 bytes to be possible and to avoid packets fragmenting
or dropping.
The speed of the Port Set, either 1Gbit or 10Gbit, depending on which ports
have been assigned.
The name of the Subnet
The VLAN tag ID for the Subnet
The IP address of the gateway
The network mask
The domain name
Indicates whether this is the Subnet that contains the default gateway
A node tab contains IP address parameters that are specific to the node.
There may be up to eight node tabs.
The IP address(es):
Two IP addresses per node on physical LANs and up to 128 IP addresses for
VLANs across all nodes.
The customer-provided IP address that is being used to add an encryption
link configuration to the subnet.
The pass phrase added when encryption was set up. To delete an encrypted
configuration, you will need this passphrase.
Editing a custom configuration 211