HPE StoreOnce 6500 User Manual page 75

Before the failure, a mapping existed between a Source Share on the remote site StoreOnce System and
a Target Share on the Data Center StoreOnce System. After the failure, the mapping still exists but the
Source Share is missing. The Target Share on the Data Center StoreOnce System is still in Target Share
mode, it has not had its mappings removed.
Procedure
1. On the Target Appliance in the Data Center, go to the Replication—NAS Mappings page, select the
Target Share, and remove the mapping between it and the lost Source Share.
2. The Target Share becomes a non-replicating share.
3. Make sure the backup application is targeting the newly non-replicating share at the data centre and
recover the data using the backup application at the data center.
4. At this point there is no StoreOnce Source Appliance at the remote site. If one is installed at a later
date, reverse recover the data and configure replication as described in Reverse replication using
the wizard on page 73.
Replication functions 75