To Set Up Static Routing - HPE StoreOnce 6500 User Manual

NOTE: HPE recommends configuring the network for expansion, in which case select 8. However, any
multiple of 2 is supported. If you need to amend the number of nodes in the configuration, see To edit
a custom configuration.
• Provide the Subnet details listed in the "Network Configuration New Subnet fields" table, and click OK.
◦ For IPv4 Subnets, select the IPv4 button and provide the relevant details.
◦ For IPv6 Subnets, select the IPv6 button and provide the relevant details.
• Repeat until all the Subnets for the selected Port Set have been defined.
◦ Each physical Port Set may be configured with one Subnet that uses the IPv4 protocol and one
Subnet that uses the IPv6 protocol.
◦ If the Port Set is VLAN enabled, it is possible to add a total of 128 IPv4 VLAN Subnets and 128
IPv6 VLAN Subnets. These total values apply across the whole network configuration, not per Port
Set.
• Click Save to save all configuration details.
NOTE: If this is a Management subnet, you can configure static routing to networks that are not
accessible via the configured gateway, if required. For example, where a Data subnet is configured for
access across the WAN and the Management subnet also requires access to a network that is not
accessible via the configured default gateway for the Management subnet. This is described in To set up
static routing.
Step 4 and 5: Validation and Activation
• Click Validate to validate the network configuration. If there are any errors, the error message will
guide you to the parts of the configuration that need correcting. Make the necessary changes, save
them and click Validate again.
• If validation is successful, you have two choices. The StoreOnce System Management GUI will prompt
you to activate the new configuration immediately. Or you can save it and activate it separately from
the Network Configuration — Custom page.
NOTE: It is not possible to activate a new configuration if storage addition is in progress.

To set up static routing

The Static Routing feature is available for the Management and storage network subnet of the system. It
may be required if access to the StoreOnce management interfaces is required from networks that are
not accessible via the configured gateway on that network. For example where the AD server is on an
isolated management network subnet with routing restrictions. A static route can be configured via a
gateway to a specific end device IP address or subnet.
A maximum of 10 IPv4 and 10 IPv6 static routes is supported for each StoreOnce System. Static routes
may be defined between the StoreOnce System and a specific host or between the StoreOnce System
and a subnet.
208 To set up static routing