HPE StoreOnce 6500 User Manual page 13

Table 1: System information parameters
Parameter
Type
Node Name
Serial Number
Cluster Management IP
Software Revision
Data VIF IPs
Status
The Status provides details about the rolled-up status of the system or Service Set and the status of the
services running.
Table 2: Status parameters
Parameter
Service Set or Overall
Status
StoreOnce Subsystem
Virtual Tape
NAS
StoreOnce Catalyst
Replication
Housekeeping
Storage Usage
Description
The model of StoreOnce System.
The node name for this Service Set.
The serial number of the entire cluster. Use this serial number when
contacting Hewlett Packard Enterprise Support. (It is the same as the serial
number on the License management on page 188 page.)
The IP address that provides access to the StoreOnce Management Console
(GUI and CLI) and applies to the whole cluster, not individual couplets.
The software revision of the node on which the Service Set is running. Use
this revision when adding couplets to check that all Service Sets are running
the latest and the same software.
The Data VIF IP addresses for data. Use these addresses when configuring
backup applications to send data to the StoreOnce System. The IP
addresses can be IPv6 or IPv4 addresses.
If VLAN tagging has been configured on your network, a scrollable list allows
you to see all the VLAN IP addresses that have been configured. For more
information about VLAN tagging, see the installation planning and preparation
guide for your product.
Description
The state of the system or service set.
The status of the background support processes such as Event Manager and
Resource Manager.
The status of the VTL service.
The status of the NAS service.
The status of the StoreOnce Catalyst service.
The status of the Replication service.
The status of the Housekeeping service.
Getting started 13