Installing The Serial Port - HPE ProLiant DL180 Gen10 User Manual

14. Power up the server.
15. If removed, install the front bezel.
The installation is complete.

Installing the serial port

Prerequisites
Before you perform this procedure, make sure that you have a hex nut screwdriver available.
Procedure
1. If installed, remove the front bezel.
2. Power down the server.
3.
Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
4.
Disconnect all peripheral cables from the server.
5. Remove the serial port blank from rear panel.
6.
Install the serial port:
a. Insert the serial port on the rear panel.
b. Install the screws.
c. Connect the serial port cable to the system board.
Hardware options installation
96