Replacing A T320 Craft Interface; Removing A T320 Craft Interface - Juniper Core Router T Series Hardware Manual
Hide thumbs
Also See for Core Router T Series:
- Monitoring and troubleshooting manual (812 pages) ,
- Handling instructions manual (12 pages)
Table of Contents
Advertisement
Replacing a T320 Craft Interface
Removing a T320 Craft Interface
Copyright © 2018, Juniper Networks, Inc.
Maintaining the T320 SCGs on page 273
The craft interface is hot-insertable and hot-removable. When you install the craft
interface, allow several minutes for the display to reflect the current state of the router.
Before you remove the craft interface, remove the front upper fan tray. For instructions
on removing a front fan tray, see
Removing a T320 Craft Interface on page 189
1.
Installing a T320 Craft Interface on page 190
2.
The craft interface is located on the front of the chassis above the FPC card cage. The
craft interface weighs approximately 2 lb (0.9 kg).
NOTE:
Removing the front upper fan tray before you remove the craft
interface might make it easier to grasp the craft interface as you remove it.
For instructions on removing a front fan tray, see
Fan Tray" on page
To remove the craft interface (see
Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect
1.
the strap to one of the ESD points on the chassis.
Completely loosen the screws at the four corners of the craft interface.
2.
Insert the blade of a flat-blade screwdriver into the slot on one side of the craft
3.
interface, then gently pry that side out from the chassis.
Repeat Step
3
for the other side of the craft interface.
4.
Grasp the craft interface by the top and bottom edges and carefully pull it straight
5.
out of the chassis.
Chapter 24: Replacing Chassis Components
"Removing a T320 Front Fan Tray" on page
199.
Figure 71 on page
190):
199.
"Removing a T320 Front
189
Advertisement
Table of Contents
Troubleshooting
