Installing The Lower Mx2020 Extended Cable Manager - Juniper MX2020 Hardware Manual

627
Figure 278: Installing the MX2020 Upper Extended Cable Manager
19

Installing the Lower MX2020 Extended Cable Manager

To install the lower extended cable manager (see Figure 279 on page 628):
1. Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect the strap to
one of the ESD points on the chassis.
2. Position the lower extended cable manager on the studs below the lower card cage.
3. Attach the lower extended cable manager using eight screws as shown in Figure 279 on page 628.
4. Replace the cable manager cover, and secure it with the two captive screws.