Mx960 Extended Cable Manager Installation Instructions; Extended Cable Manager Description - Juniper MX960 Hardware Manual

MX960 Extended Cable Manager Installation Instructions

IN THIS SECTION

Extended Cable Manager Description | 283

Installing the Extended Cable Manager | 285
Powering On the Router | 315
Verifying the Extended Cable Manager Is Correctly Installed | 316
Dressing the Cables | 317
This topic describes how to install the extended cable manager on a Juniper Networks MX960 Universal
Routing Platform.
NOTE: This installation procedure requires you to power down the router.
Read this document completely before you install the extended cable manager.
Extended Cable Manager Description
The extended cable manager allows you to manage a large number of fiber-optic and copper cables attached
to the Dense Port Concentrators (DPCs) installed in the router. It is installed in the top of the MX960
chassis.
The extended cable manager consists of the following parts (see
Figure 73 on page 284):
Top hat assembly—A sheet metal assembly that contains the cable routing channels and cable routing
bay cover, the front panel ribbon cable, and the double-sided electrical connector for the upper fan tray.
Rear air exhaust grate—Replaces the existing air exhaust grate and attaches to the rear of the top hat
assembly and the chassis.
Cable routing bay cover—Covers the cable routing channels and attaches to the front of the top hat
assembly.
Two 8-32 screws—Secure the top hat assembly to the rear of the chassis.
Figure 72 on page 284 and
283