Installing The Mx2020 Router Using A Pallet Jack With Attachment; Figure 52: Removing A Cb-Re; Reinstalling Components In The Mx2020 Chassis After Installing It With A Pallet - Juniper MX2020 Hardware Manual

MX2020 3D Universal Edge Router Hardware Guide
Related
Documentation

Installing the MX2020 Router Using a Pallet Jack with Attachment

96

Figure 52: Removing a CB-RE

0
Preventing Electrostatic Discharge Damage to an MX2020 Router on page 320
MX2020 Site Preparation Checklist on page 67
Tools Required to Install the MX2020 Router Using a Pallet Jack on page 86
Installing the MX2020 Router Using a Pallet Jack with Attachment on page 96
Reinstalling Components in the MX2020 Chassis After Installing It with a Pallet Jack
on page 99
Because of the router's size and weight—up to 1,500 lb (680.39 kg) depending on the
configuration—you must use a pallet jack with attachment to install the router.
NOTE: Four persons are needed to install the router into a rack.
CAUTION: Before front mounting the router in a rack, have a qualified
technician verify that the rack is strong enough to support the router's weight
and is adequately supported at the installation site.
19
Copyright © 2013, Juniper Networks, Inc.