Using The Touch Strips - Native Instruments Maschine Manual

Hide thumbs Also See for Maschine:

Table of Contents

Knob 5 (SEQUENCE)

OTHER Section

Knob 6 (OCTAVES)

Knob 7 (DYNAMIC)

Knob 8 (GATE)

As when your KOMPLETE KONTROL S-SERIES keyboard is connected to the KOM-

PLETE KONTROL software, the displays below the first four Knobs always show the pa-

rameter values — as opposed to other Knobs whose displays show the parameter name

by default and the parameter value when touched. This provides a quicker way of check-

ing important parameters in a live situation, since their values are quite self-explanatory.

To sum up, all Arp parameter values are always synchronized between your KOMPLETE KON-

TROL S-SERIES keyboard and the connected controller from the MASCHINE family. Again, all

these parameters are described in section Scale and Chord Parameters.

Using the Touch Strips

When your keyboard is focused on a MASCHINE instance, its left and right touch strips always

send Pitch and Modulation data to the focused Sound, respectively.

The way Pitch and Modulation data is interpreted can vary with the Plug-in loaded in the

focused Sound. For example, MASCHINE's Sampler Plug-in lets you configure various

destinations for the Modulation data (in the

Velocity / Modwheel

Selects a Sequence for the arpeggio. This parameter is shared with

MASCHINE controllers.

Adjusts the Octaves parameter. This parameter is shared with

MASCHINE controllers.

Adjusts the Dynamic parameter. This parameter is shared with

MASCHINE controllers.

Adjusts the Gate parameter. This parameter is shared with

MASCHINE controllers.

MODWHEEL DESTINATION

page, in the Control area).

KOMPLETE KONTROL Integration

Using the Touch Strips

section of the

MASCHINE 2 - Manual - 682