Enabling Nonstandard Pd Detection; Configuring The Maximum Pi Power - HPE FlexNetwork 5510 HI Series Network Management And Monitoring Configuration Manual

The switch series transmits power over signal wires.
NOTE:
A PSE can supply power to a PD directly only when the PSE and PD use the same power
transmission mode. If the PSE and PD use different power transmission modes, you must change
the order of the lines in the twisted pair cable to supply power to the PD.
To enable PoE for a PI:
Step
1. Enter system view.
2. Enter PI view.
3. Enable PoE for the PI.
4. (Optional.)
description
connected to the PI.

Enabling nonstandard PD detection

By default, the PSE detects only IEEE 802.3af-compliant standard PDs and supplies power to them.
To enable nonstandard PD detection:
Step
1. Enter system view.
2. Enable nonstandard PD
detection.

Configuring the maximum PI power

The maximum PI power is the maximum power that a PI can provide to the connected PD. If the PD
requires more power than the maximum PI power, the PI does not supply power to the PD.
A PSE uses LLDP to negotiate the PI power with a PD after you perform the following tasks:
•
Enable PoE and LLDP on the PSE.
•
Enable PoE and LLDP, and specify the dot3-tlv power keyword in the lldp tlv-enable
command on the PI.
For more information about LLDP, see Layer 2—LAN Switching Configuration Guide.
To configure the maximum PI power:
Step
1. Enter system view.
2. Enter PI view.
3. Configure
power for the PI.
Command
system-view
interface
interface-number
poe enable
Configure a
for the PD
poe pd-description text
Command
system-view
poe legacy enable pse pse-id
Command
system-view
interface
interface-number
the maximum
poe max-power max-power
interface-type
interface-type
226
Remarks
N/A
N/A
By default, PoE is disabled for a
PI.
By default, no description is
available for the PD connected to
the PI.
Remarks
N/A
By default, nonstandard PD
detection is disabled.
Remarks
N/A
N/A
The default maximum PI power is
30000 milliwatts.