Retrieve Jcc Output Parameters - Symmetricom SSU-2000 Technical Reference

Chapter 2 TL1 Reference

Retrieve JCC Output Parameters

Retrieve JCC Output Parameters
This command returns the settings for the Japan Composite Clock module or port
specified by the aid.
Syntax
RTRV-PRMTR-OUTJCC:[tid]:[aid]:ctag;
Parameter
[aid]
Response Format
When the aid specifies a port, the response is:
^^^"aid:bypass,400hz,pstate,pcomp"<cr lf>
where:
= port access identifier
aid
= allow Clock C selection [ON | OFF]
bypass
= port state (enabled/disable) [ON | OFF]
pstate
= 400 Hz BPV removal [ON | OFF]
400hz
= phase compensation [0 through 7] where 7 = No compensation and 0 =
pcomp
2200 ft; the resolution of pcomp values is 275 ft
When the aid specifies a module, the response is:
^^^"aid:bypass,400hz"<cr lf>
^^^"aid:pstate1,pstate2,...pstate20"<cr lf>
^^^"aid:pcomp1,pcomp2,...pcomp20"<cr lf>
where:
Line 1 contains:
= module access identifier
aid
= 400 Hz BPV removal [ON | OFF]
400hz
= [ON | OFF] for allowing Clock C selection
bypass
Line 2 contains:
= module access identifier
aid
= port enabled state [0 | 1] (0 is Off, 1 is On) and
pstate#
[1 – 20]
82 SSU-2000 Technical Reference
Value
Retrieves the parameters from all JCC Output modules in
ALL
the shelf.
Retrieves parameters from the specified JCC Output
SxAy[-z]
module [or port].
Description
is the port number
#
12713020-003-2 Revision F.01 – January 2007