Table of Contents
Advertisement
Chapter 3 ICS Command Reference
MTIE
MTIE
Use this command to display the MTIE (Maximum Time Interval Error) data from a
selected input port. MTIE is a measure of wander that characterizes frequency
offsets and phase transients. MTIE (tau) is the largest Peak-to-Peak TIE (Time
Interval Error) in any observation interval of length tau.
Level 0
Not applicable
Level 1
MTIE xAy-z [{A|B}] startdate [starttime][stopdate [stoptime]]
MTIE xAy-z [{A|B}] starttime [stopdate][stoptime]
MTIE xAy-z [{A|B}] HISTORY [count]
Options are:
A| B
starttime
stopdate
stoptime
HISTORY [count]
This command displays the MTIE information calculated on the input
module with a specified clock. A start time and stop time are required to
perform an MTIE calculation. If these are not specified in the command
line, the
the current time.
Note: If you specify times and dates, the MTIE that occurred after the
starting date and time and before the ending date and time displays.
Specified dates have the format yyyy-mm-dd, and specified times
have the format hh:mm:ss. Specified dates and times are not
provided in ISO timestamp format, and must be separated by a
space. Starttime and stoptime both default to the current time of day.
Stopdate defaults to the current date. Startdate defaults to the current
date, minus 24 hours.
224 SSU-2000 Technical Reference
CLK A or CLK B; the default is the selected clock output.
Specifies the start time of a specific period of time to be
displayed.
Specifies the date ending a specific period of time to be
displayed.
Specifies the stop time of a specific period of time to be
displayed.
If the starttime, stopdate, and stoptime are not specified,
the system defaults to a 24 hour period.
Displays the one-day MTIE history for the last number of
days specified in the count parameter.
defaults to the last 24 hours, the
starttime
stoptime
12713020-003-2 Revision F.01 – January 2007
defaults to
Advertisement
Table of Contents
