E1/2048 Khz Output Module Alarm Defaults - Symmetricom SSU-2000 Technical Reference

Table 6-28. E1/2048 kHz Output Module Alarm and Event Messages (Continued)
Alarm/
Typical Alarm/Event/Trap
Event/
Response
Trap ID
193 Signal, Port[1-20], E1, COML
194 Port Cntl, Port[1-20],
Enable, COML
195 ZS, On, COML
196 Bypass, On, COML
197 Squelch, Port[5-10], 6, COML
198 Multiframe, CCS, COML
199 CRC, On, COML
200 SSM, Auto, COML
201 SSM Bit, 4, COML
224 IoName, Set
252 Alm Level, (1), Min, COML
253 Elevate Time, 86400 sec,
COML
254 Setup, User Default, COML
Table 6-29. E1/2048 kHz Output Module Alarm Defaults
ID Description
000 Hdw Config
001 Configuration
002 Clk-A
003 Clk-B
004 Clk-C
005 Clk-D
006 Clk Selected,
007 VCXO
008 PLL
009 Sync
010 Squelch
011 PortFlt
12713020-003-2 Revision F.01 – January 2007
E1/2048 kHz Output Module Alarms and Events
Corrective Action
Output framing type change.
User has enabled | disabled specified port.
User has changed Zero Suppression mode.
User has changed Bypass mode.
User has changed squelch PQL level.
User has changed multiframe setting.
User has changed CRC setup.
User has changed SSM setting.
User has changed SSM bit position.
User has changed the port name.
User has changed time to elevate alarm level.
An alarm elevation time change.
User has reset setup to user-defined default values.
Alarm Level
Major
Major
Major
Major
Major
Major
Major
Major
Major
Major
Major
Major
Chapter 6 Alarms and Events
Description/
SSU-2000 Technical Reference 327