Table of Contents
Advertisement
Table 6-4. Basic and Basic +NTP Communications Module Alarm and Event Messages (Continued)
Alarm/
Typical Alarm/Event/Trap
Event/
Response
Trap ID
009
Detect Mdl Removed, Fault
105
KeepAlive, SSU2000
129
Install, Comm Module
130
Remove, Comm Module
131
Enable, Comm Module,
COML
132
Disable, Comm Module,
COML
133
Restart, in 5 seconds,
COML
144
Log In, JAY, COML, level: 2
145
Log Out,TIM, COML, level: 2
146
Auto Out, TIM, COML, level: 3
147
Msg, <HELLO BILL>, COML
148
Not Acknowledged, 1A01
150
Module Status, Fault, 1A04
151
UTC Time, Valid
152
TODSYNC, Timeout
153
Upload Image, Start
154
Upgrade, 1A02
155
Upgrade ACK, 1A02
156
Upgrade NAK, 1A02
157
Config, 1A06, Not Support
158
NTP Mode, GPS
159
Reset, Clk-B, COML
160
Clk-C Source, 1A04-01
161
Sync Clk-C, Start
12713020-003-2 Revision F.01 – January 2007
Corrective Action
A module has been removed from the system or is not responding
to Comms module queries. Replace the removed module with the
same type, or issue the command CONFIG xAy REMOVE to
remove the module information from the system database.
The Keep Alive function has been enabled/ disabled.
The Comms module has been installed.
The Comms module has been removed.
The Comms module has been enabled.
The Comms module has been disabled.
The Comms module has been rebooted (Warm boot).
User at indicated level has logged in.
User at indicated level has logged out.
System automatically logging out a user.
Message sent from a user.
Module configuration could not be obtained.
Module did not boot properly.
Time of startup; NTP is enabled but GPS time not being used.
Time of day (TOD) was requested by the Comms module, no
response from the GPS module.
System firmware upgrade status.
Module's firmware upgrade has started.
Module's firmware upgrade was completed.
Module's firmware upgrade was not completed.
Call Symmetricom Global Services. Return to factory.
The SSU is configured with NTP running in an NTP Client,
Broadcast, or Broadcast Client server mode; Local is displayed
when NTP server is initialized. If GPS is not installed or setup, or
NTP has not been configured NTP remains in Local mode and uses
Comms module time.
A user has reset the specified clock.
Bypass clock source has changed.
Status of Sync acquire operation.
Chapter 6 Alarms and Events
Communication Module Alarms and Events
Description/
SSU-2000 Technical Reference 295
Advertisement
Table of Contents
