Table of Contents
Advertisement
Chapter 2 TL1 Reference
Set E1/2048 kHz Output Parameters
Set E1/2048 kHz Output Parameters
This command sets the output parameters for the specified E1/2048 kHz Output
module or port.
Syntax
SET-PRMTR-OUTE12048:[tid]:[aid]:ctag::[pstate],[bypass],[zs],
[signal],[squelch],[mframe],[crc],[ssm],[bit];
Parameter
aid
pstate
bypass
zs
signal
squelch
mframe
crc
ssm
bit
Related Commands
Retrieve E1/2048 kHz Output
146 SSU-2000 Technical Reference
Format
Sets the parameters for the specfied module [or port].
SxAy[-z]
Enables or disable the specified module [or port].
ON | OFF
Allows operation when Clock C is the active clock.
ON | OFF
Turns zero suppression on or off for the specified module
ON | OFF
[or port].
Sets the output mode of the specified module [or port].
E1 | 2048
Turns off the specified port if the reference clock PQL
0 | 1 - 16
exceeds the squelch threshold specified in this field. 0
disables the function.
Sets the multiframe mode for the specified module [or
CAS | CCS
port].
Eanbles or disables error checking.
ON | OFF
Sets the specified module [or port] to read or ignore
ON | OFF
incoming Sync Status Messages.
Sets the bit number of the Time Slot 0 word used for the
4 - 8
E1 SSM.
Parameters, on page 60
Description
12713020-003-2 Revision F.01 – January 2007
Advertisement
Table of Contents
