Set Ntp Parameters - Symmetricom SSU-2000 Technical Reference

Synchronization supply unit and synchronization distribution unit
Hide thumbs Also See for SSU-2000:
Table of Contents

Advertisement

Set NTP Parameters

This command sets the NTP client and NTP broadcast mode of operation.
Syntax
SET-PRMTR-NTP:[tid]::ctag::mode,ip,interval,prefer;
Parameter
mode
ip
interval
prefer
Related Commands
Retrieve NTP
12713020-003-2 Revision F.01 – January 2007
Format
Sets the mode of operation, where:
CLIENT |
BCLIENT |
Client mode requests the time from the time server
BROADCAST |
(specified by ip); this time sets the time in the SSU.
DEL |
Bclient mode accepts time from a broadcast
CLRALL
server specified by ip.
Broadcast mode configures the SSU as a
broadcast time server at the specified ip, the
broadcast interval (in seconds) defines the rate at
which the time will be broadcast by the server.
The del mode deletes the server specified by ip
from the list of peers; up to three ip's can be
assigned for all peer modes combined.
Clrall deletes all peer addresses. If three ip's have
been defined and a fourth ip is defined, the system
returns a DENY message; you must delete one of
the existing ip's prior to adding the new ip.
Sets the IP address of the NTP server.
Sets the rate (in seconds) at which the time is to be
broadcast by the server.
Selects the time-of-day source in the SSU from GPS or
GPS |
an NTP client.
CLIENT
Parameters, on page 95
Chapter 2 TL1 Reference
Set NTP Parameters
Description
SSU-2000 Technical Reference 163

Advertisement

Table of Contents
loading

This manual is also suitable for:

Sdu-2000

Table of Contents