Ds1 And E1 Line Re-Timing Module Default Settings; Ds1 Line Re-Timing Module Configuration - Symmetricom SSU-2000 Technical Reference

Table 8-8. Japanese Sine Wave Input Module Configuration Settings (Continued)
Configuration Setting
MTIE T10K Clear Limit 1
MTIE T10K Clear Limit 2
MTIE T100K Clear Limit 1
MTIE T100K Clear Limit 2
MTIE Limit 1 Alarm Mode
MTIE Limit 2 Alarm Mode
Alarm Severity
Alarm Set Delay
Alarm Elevation Time
Port Status
Port Name

DS1 and E1 Line Re-timing Module Default Settings

Table 8-9 lists settings and factory defaults for the Line Re-timing Modules.
Table 8-9. DS1 Line Re-timing Module Configuration
Configuration Setting
Slips Threshold
Fault Strategy
Port Enable
Port LBO
Circuit ID
12713020-003-2 Revision F.01 – January 2007
Factory Default
790
990
1440
1800
Minor
Major
Minor for most alarms
Major for LOS
0 seconds
86 400 seconds
Disabled
Factory
Default
DS1 Line Re-Timing Module
Error = 4, 1 to 255 (in any 24 hour period)
Clear <4
AIS AIS
SQUELCH
Enabled Enabled
Disabled
1 (0-133 ft) 1 = 0–133 ft
2 = 133–266 ft
3 = 266–399 ft
4 = 399–533 ft
5 = 533–655 ft
None (blank) String from 0-43 characters (only valid TL1 characters
are supported)
DS1 and E1 Line Re-timing Module Default Settings
Range
0 to 60 000
0 to 60 000
0 to 60 000
0 to 60 000
Ignore | Report | Minor | Major | Critical
Ignore | Report | Minor | Major | Critical
Ignore | Report | Minor | Major | Critical
0 to 172 800 seconds
60 to 500 000 seconds, 0 is disabled
Enabled/Disabled
Any user-selected string from 0–20 chars
Range
SSU-2000 Technical Reference 355
Chapter 8 Default Settings